+86-028-85255257
F-tone QSFP-56G-SR4 56Gb/s QSFP+ SR4
Features
Applications
Description
The F-tone Technologies GQS-MP560-SR4C is a Four-Channel, Pluggable, Parallel, Fiber-Optic QSFP+ Transceiver for InfiniBand FDR/QDR/DDR/SDR,16G/10G/8G/4G/2G fiber channel , PCIe and SAS Applications. This transceiver is a high performance module for short-range multi-lane data communication and interconnect applications. It integrates four data lanes in each direction with 56 Gbps bandwidth. Each lane can operate at 14.025 Gbps up to 100 m using OM3 fiber or 150 m using OM4 fiber. These modules are designed to operate over multimode fiber systems using a nominal wavelength of 850nm. The electrical interface uses a 38 contact edge type connector. The optical interface uses an 12 fiber MTP (MPO) connector. This module incorporates F-tone Technologies proven circuit and VCSEL technology to provide reliable long life, high performance, and consistent service.QSFP+ SR4 is one kind of parallel transceiver. VCSEL and PIN array package is key technique, through I2C system can contact with module.
Absolute Maximum Ratings
Parameter |
Symbol |
Min |
Max |
Unit |
Supply Voltage |
Vcc |
-0.3 |
3.6 |
V |
Input Voltage |
Vin |
-0.3 |
Vcc+0.3 |
V |
Storage Temperature |
Tst |
-20 |
85 |
?C |
Case Operating Temperature |
Top |
0 |
70 |
?C |
Humidity(non-condensing) |
Rh |
5 |
95 |
% |
Recommended Operating Conditions
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Supply Voltage |
Vcc |
3.13 |
3.3 |
3.47 |
V |
Operating Case temperature |
Tca |
0 |
70 |
?C |
|
Data Rate Per Lane |
fd |
2.5 |
14.025 |
Gbps |
|
Humidity |
Rh |
5 |
85 |
% |
|
Power Dissipation |
Pm |
1.5 |
W |
||
Fiber Bend Radius |
Rb |
3 |
cm |
Electrical Specifications
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Differential input impedance |
Zin |
90 |
100 |
110 |
ohm |
Differential Output impedance |
Zout |
90 |
100 |
110 |
ohm |
Differential input voltage amplitude aAmplitude |
¦¤Vin |
300 |
1100 |
mVp-p |
|
Differential output voltage amplitude |
¦¤Vout |
500 |
800 |
mVp-p |
|
Skew |
Sw |
300 |
ps |
||
Bit Error Rate |
BR |
E-12 |
|||
Input Logic Level High |
VIH |
2.0 |
VCC |
V |
|
Input Logic Level Low |
VIL |
0 |
0.8 |
V |
|
Output Logic Level High |
VOH |
VCC-0.5 |
VCC |
V |
|
Output Logic Level Low |
VOL |
0 |
0.4 |
V |
Note£º
2. Differential input voltage amplitude is measured between TxNp and TxNn.
3. Differential output voltage amplitude is measured between RxNp and RxNn.
Optical Characteristics
Table 3 - Optical Characteristics
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
|
Transmitter |
|||||||
Centre Wavelength |
¦Ëc |
840 |
850 |
860 |
nm |
- |
|
RMS spectral width |
?¦Ë |
- |
- |
0.65 |
nm |
- |
|
Average launch power, each lane |
Pout |
-7.5 |
- |
2.5 |
dBm |
- |
|
Difference in launch power between any two lanes (OMA) |
4 |
dB |
- |
||||
Extinction Ratio |
ER |
3 |
- |
- |
dB |
- |
|
Peak power, each lane |
4 |
dBm |
- |
||||
ransmitter and dispersion penalty (TDP), each lane |
TDP |
3.5 |
dB |
- |
|||
Average launch power of OFF transmitter, each lane |
-30 |
dB |
- |
||||
Eye Mask coordinates: X1, X2, X3, Y1, Y2, Y3 |
SPECIFICATION VALUES 0.23, 0.34, 0.43, 0.27, 0.35, 0.4 |
Hit Ratio = 5x10-5 |
|||||
Receiver |
|||||||
Centre Wavelength |
¦Ëc |
840 |
850 |
860 |
nm |
- |
|
Stressed receiver sensitivity in OMA, each lane |
-5.4 |
dBm |
1 |
||||
Average power at receiver input, each lane |
-9.5 |
2.4 |
dBm |
- |
|||
Receiver Reflectance |
-12 |
dB |
- |
||||
Peak power, each lane |
4 |
dBm |
- |
||||
LOS Assert |
-30 |
dBm |
- |
||||
LOS De-Assert ¨C OMA |
-7.5 |
dBm |
- |
||||
LOSHysteresis |
0.5 |
dB |
- |
||||
Note£º
1£®Measured with conformance test signal at TP3 for BER = 10e-12
¶©»õÐÅÏ¢/Ordering information :
Part No. | Description |
QSFP-56G-SR4 | QSFP SR4,56G,0¡ãC to 70¡ãC |
QSFP-56G-SR4I | QSFP SR4,56G, -40¡ãC to 85¡ãC |