+86-028-85255257
Description
F-tone Networks 1000BASE-T copper SFP transceiver is based on the SFP Multi-Source Agreement (MSA). They are compatible with the Gigabit Ethernet and 1000BASE-T standards as specified in IEEE Std 802.3, which support 1000Mbps data-rate up to 100 meter reach over unshielded twisted-pair category-5 cable.
There are total five kinds of products for selection in this series:
MXP-24RJX, SERDES interface with auto-negotiation enable default.
MXP-24RJNDX, SERDES interface with auto-negotiation enabled default, and support RX_LOS as link indication function.
MXP-24RJFDX, SERDES interface with auto-negotiation enabled default, and support RX_LOS as link indication function.
MXP-24RJSX, SGMII interface with auto-negotiation enable default.
MXP-24RJSDX, SGMII interface with auto-negotiation enabled default, and support RX_LOS as link indication function.
The transceiver supports 1000Mbps full duplex data-links with 5-level Pulse Amplitude Modulation (PAM) signals. All four pairs in the cable are used with symbol rate 250Mbps on each pair.
The transceiver provides standard serial ID information compatible with SFP MSA, which can be accessed with address of A0h via the two-wire serial CMOS EEPROM Protocol. The physical IC can be also be accessed via two-wire serial bus at address ACh.
Features
¡ñ Up to 1.25Gbps bi-directional data links
¡ñ SFP form with compact RJ-45 connector
¡ñ Single +3.3V power supply
¡ñ 10/100/1000 BASE-T operation in host systems with SGMII interface (MXP-24RJSX,MXP-24RJSDX)
¡ñ 1000BASE-T operation in host systems with SERDES interface (MXP-24RJX,MXP-24RJNDX,MXP-24RJFDX)
¡ñ Intelligent Auto-Negotiation support for automatic duplex ,speed and flow control resolution
¡ñ Link lengths: up to 100 meter
¡ñ Detailed product information in EEPROM
¡ñ Physical layer IC can be accessed via 2-wire serial bus
¡ñ For 100m reach over cat 5 UTP cable
¡ñ Low power consumption
¡ñ Operate temperature range:
C-temp: -5~70¡æ
I-temp:-40~85¡æ
Applications
¡ñ 1.25 Gigabit Ethernet over Cat 5 cable
Compliance
¡ñ Compatible with SFP MSA
¡ñ Compatible with IEEE Std 802.3
¡ñ ROHS
[1] MXP-24RJXX contains C-temp and I-temp productions. The first” X “combined with 24RJ indicate production models, e.g.MXP-24RJS, MXP-24RJS. And the second “X” indicates operation temperature: “I” is Industrial temperature range, and when “X” is omitted indicates commercial temperature range.
Specification
Absolute Maximum Ratings |
||||||
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
Storage Temperature |
TSTG |
-40 |
- |
+85 |
ºC |
|
Operating Relative Humidity |
RH |
5 |
- |
85 |
% |
|
Supply Voltage |
VCC |
-0.5 |
- |
+3.6 |
V |
|
Recommended Operating Conditions |
||||||
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
Ambient temperature |
Ta |
-5 |
- |
+70 |
¡æ |
C-temp |
-40 |
- |
+85 |
¡æ |
I-temp |
||
Supply Voltage |
VCC |
3.135 |
3.3 |
3.465 |
V |
|
Power Supply Current |
Icc |
|
|
390 |
mA |
Note1 |
|
|
410 |
mA |
Note2 |
Electrical Characteristic |
|||||||||
Parameter |
Symbol |
Min |
Typical |
Max |
Unit |
Notes |
|||
Differential Input Voltage |
Vin p-p |
500 |
- |
2400 |
mV |
Note3¡¢4 |
|||
Differential Output Voltage |
Vout p-p |
500 |
- |
1200 |
mV |
Note3¡¢4 |
|||
Data rate |
|
10 |
|
1000 |
Mbps |
Note5 |
|||
Bit Error Rate |
BER |
|
|
10-10 |
|
Note6 |
|||
Compliance test(1000Mbps) |
|||||||||
Template |
Fit the Template |
||||||||
Peak Volt Point A |
Va p-p |
670 |
|
820 |
mV |
|
|||
Peak Volt Point B |
Vb p-p |
670 |
|
820 |
mV |
|
|
||
%Diff A and B |
|
|
|
1 |
% |
|
|
||
Peak Volt %Diff C |
|
|
|
2 |
% |
|
|
||
Peak Volt %Diff D |
|
|
|
2 |
% |
|
|
||
Droop Point G |
|
73.1 |
|
|
% |
|
|
||
Droop Point J |
|
73.1 |
|
|
% |
|
|
||
Transmitter Distortion |
|
|
|
10 |
mV |
|
|
||
Common-mode Output Voltage |
|
|
|
50 |
mV |
|
|
||
Compliance test(100Mbps)(MXP-24RJSX¡¢MXP-24RJSDX) |
|
||||||||
+Vout Differential Output Voltage |
|
950 |
|
1050 |
mV |
|
|
||
-Vout Differential Output Voltage |
|
950 |
|
1050 |
mV |
|
|
||
Signal Amplitude Symmetry |
|
980 |
|
1020 |
mV |
|
|
||
+Vout Overshoot |
|
|
|
5 |
% |
|
|
||
-Vout Overshoot |
|
|
|
5 |
% |
|
|
||
AOI Template |
Fit the template |
|
|||||||
AOI +Vout Rise Time |
|
3 |
|
5 |
ns |
|
|
||
AOI +Vout Fall Time |
|
3 |
|
5 |
ns |
|
|
||
AOI +Vout Rise/Fall Symmetry |
|
|
|
500 |
ps |
|
|
||
AOI -Vout Rise Time |
|
3 |
|
5 |
ns |
|
|
||
AOI -Vout Fall Time |
|
3 |
|
5 |
ns |
|
|
||
AOI -Vout Rise/Fall Symmetry |
|
|
|
500 |
ps |
|
|
||
AOI Overall Rise/Fall Symmetry |
|
|
|
500 |
ps |
|
|
||
Transmit Jitter |
|
|
|
1.4 |
ns |
|
|
||
Duty Cycle Distortion |
|
|
|
500 |
ps |
|
|
||
Notes:
[1] Full temperature range for C-temp application.
[2] Full temperature range for I-temp application
[3] Internally ac coupled and terminated (100 Ohm differential).
[4] Internally ac coupled with an external 100 Ohm differential load termination.
[5] 10/100/1000 BASE-T operate requires the host systems to have an SGMII interface with no clocks, and the module will operate as 1000BASE-T only when the host system use SERDES interface.
[6] Measured over 100m Cat-5 UTP cable.
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.